You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Is your feature request related to a problem? Please describe.
In it's current implementation the G34 Z-stepper auto align command does not respect any compensation values set through the (relatively) new X-twist wizard.
This causes the gantry to be out of alignment after running G34 and following ABL procedures to produce useless mesh values.
Right now the G34 command is pretty much useless on machines with a twisted X-axis and setting the stepper alignment has to be done manually to get meaningful mesh bed leveling results.
Are you looking for hardware support?
No response
Describe the feature you want
Change the G34 code to respect the compensation values set by the X-twist command (M423)
Additional context
No response
The text was updated successfully, but these errors were encountered:
Is your feature request related to a problem? Please describe.
In it's current implementation the G34 Z-stepper auto align command does not respect any compensation values set through the (relatively) new X-twist wizard.
This causes the gantry to be out of alignment after running G34 and following ABL procedures to produce useless mesh values.
Right now the G34 command is pretty much useless on machines with a twisted X-axis and setting the stepper alignment has to be done manually to get meaningful mesh bed leveling results.
Are you looking for hardware support?
No response
Describe the feature you want
Change the G34 code to respect the compensation values set by the X-twist command (M423)
Additional context
No response
The text was updated successfully, but these errors were encountered: