TX23 anemometer does not work in ESP32 modules

[valdus2]

Tried esp32-devkit ESP32-D0WD-V3 v3.0 and ESP32-D0WD-V3 v3.1, also ESP32D.

Compiled either release or development from 13.4.0.4 to 13.4.1.2.

Configuring different GPIOs (13,18,23,26,34).

Connected it with and without external 10k pull-up resistor.

All I get is the below screen for 3 seconds and then it disappears.

In GPIO viewer I can see the defined gpio alternating between high and low every about 4 seconds.

This is a weblog4 from latest release compiled with tx23:

00:00:00.003 HDW: ESP32-D0WD-V3 v3.0 
00:00:00.007 UFS: FlashFS mounted with 304 kB free
00:00:00.013 CFG: Loaded from File, Count 67
00:00:00.023 QPC: Count 1
00:00:00.025 CFG: CR 414/699, Busy 0
00:00:00.030 TYA: Active=0
00:00:00.036 ROT: Mode 1
00:00:00.047 BRY: GC from 3692 to 3492 bytes, objects freed 4/20 (in 0 ms) - slots from 36/61 to 28/61
00:00:00.068 CFG: No '*.autoconf' file found
00:00:00.074 BRY: GC from 5852 to 4446 bytes, objects freed 6/40 (in 0 ms) - slots from 64/91 to 41/91
00:00:00.074 BRY: Berry initialized, RAM used 4446 bytes
00:00:00.082 BRY: No 'preinit.be'
00:00:00.085 SRC: Restart
00:00:00.089 Project tasmota - Tasmota Version 13.4.0(DigiESP32meteo_v24_1b)-2_0_14(2024-05-08T21:31:44)
00:00:00.090 ETH: No ETH MDC and ETH MDIO GPIO defined
00:00:00.105 BRY: No 'autoexec.be'
00:00:00.246 WIF: Checking connection...
00:00:00.247 WIF: Attempting connection...
00:00:00.882 WIF: Connecting to AP1 default3 Channel 10 BSSId 14:EB:B6:B7:A4:FE in mode 11n as tasmota-75A3F8-1016...
00:00:02.213 WIF: IPv4 192.168.0.64, mask 255.255.255.0, gateway 192.168.0.254
00:00:03.424 WIF: IPv6 Local fe80::e25a:1bff:fe75:a3f8%st1
00:00:03.447 WIF: Checking connection...
00:00:03.447 WIF: Connected
00:00:03.706 HTP: Web server active on tasmota-75A3F8-1016 with IP address 192.168.0.64
00:00:03.999 NTP: Sync time...
00:00:04.059 WIF: DNS resolved '2.pool.ntp.org' (162.159.200.1) in 58 ms
00:00:04.085 RTC: UTC 2024-05-08T21:49:09Z, DST 2024-03-31T02:00:00, STD 2024-10-27T03:00:00
22:49:09.000 RTC: Synced by NTP
22:49:09.613 MQT: Attempting connection...
22:49:09.616 WIF: DNS resolved '192.168.0.5' (192.168.0.5) in 1 ms
22:49:09.645 MQT: Connected
22:49:09.650 MQT: tele/tasmota_75A3F8/LWT = Online (retained)
22:49:09.652 MQT: cmnd/tasmota_75A3F8/POWER = 
22:49:09.653 MQT: Subscribe to cmnd/tasmota_75A3F8/#
22:49:09.655 MQT: Subscribe to cmnd/tasmotas/#
22:49:09.656 MQT: Subscribe to cmnd/DVES_75A3F8_fb/#
22:49:09.660 MQT: tele/tasmota_75A3F8/INFO1 = {"Info1":{"Module":"ESP32-DevKit","Version":"13.4.0(DigiESP32meteo_v24_1b)","FallbackTopic":"cmnd/DVES_75A3F8_fb/","GroupTopic":"cmnd/tasmotas/"}}
22:49:09.678 MQT: tele/tasmota_75A3F8/INFO2 = {"Info2":{"WebServerMode":"Admin","Hostname":"tasmota-75A3F8-1016","IPAddress":"192.168.0.64","IP6Global":"","IP6Local":"fe80::e25a:1bff:fe75:a3f8%st1"}}
22:49:09.693 MQT: tele/tasmota_75A3F8/INFO3 = {"Info3":{"RestartReason":"Software reset CPU","BootCount":39}}
22:49:09.708 TFS: File 'autoexec.bat' not found
22:49:11.964 QPC: Reset
22:49:12.605 HTP: Main Menu
22:49:13.985 APP: Boot Count 39
22:49:13.988 BRY: GC from 6374 to 4212 bytes, objects freed 26/45 (in 1 ms) - slots from 91/122 to 50/122
22:49:13.998 MQT: tele/tasmota_75A3F8/STATE = {"Time":"2024-05-08T22:49:13","Uptime":"0T00:00:09","UptimeSec":9,"Heap":151,"SleepMode":"Dynamic","Sleep":50,"LoadAvg":19,"MqttCount":1,"Berry":{"HeapUsed":4,"Objects":45},"Wifi":{"AP":1,"SSId":"default3","BSSId":"14:EB:B6:B7:A4:FE","Channel":10,"Mode":"11n","RSSI":74,"Signal":-63,"LinkCount":1,"Downtime":"0T00:00:04"}}
22:49:14.430 CFG: Saved, Count 68, Bytes 4096
22:49:19.020 MQT: tasmota/discovery/E05A1B75A3F8/config = {"ip":"192.168.0.64","dn":"Tasmota","fn":["Tasmota",null,null,null,null,null,null,null],"hn":"tasmota-75A3F8-1016","mac":"E05A1B75A3F8","md":"ESP32-DevKit","ty":0,"if":0,"ofln":"Offline","onln":"Online","state":["OFF","ON","TOGGLE","HOLD"],"sw":"13.4.0","t":"tasmota_75A3F8","ft":"%prefix%/%topic%/","tp":["cmnd","stat","tele"],"rl":[0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0],"swc":[-1,-1,-1,-1,-1,-1,-1,-1,-1,-1,-1,-1,-1,-1,-1,-1,-1,-1,-1,-1,-1,-1,-1,-1,-1,-1,-1,-1],"swn":[null,null,null,null,null,null,null,null,null,null,null,null,null,null,null,null,null,null,null,null,null,null,null,null,null,null,null,null],"btn":[0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0],"so":{"4":0,"11":0,"13":0,"17":0,"20":0,"30":0,"68":0,"73":0,"82":0,"114":0,"117":0},"lk":0,"lt_st":0,"bat":0,"dslp":0,"sho":[],"sht":[],"ver":1} (retained)
22:49:19.027 MQT: tasmota/discovery/E05A1B75A3F8/sensors = {"sn":{"Time":"2024-05-08T22:49:19"},"ver":1} (retained)
22:49:28.450 WIF: Checking connection...
22:49:33.958 BRY: GC from 4567 to 4212 bytes, objects freed 1/45 (in 0 ms) - slots from 51/122 to 50/122
22:49:33.969 MQT: tele/tasmota_75A3F8/STATE = {"Time":"2024-05-08T22:49:33","Uptime":"0T00:00:29","UptimeSec":29,"Heap":150,"SleepMode":"Dynamic","Sleep":50,"LoadAvg":19,"MqttCount":1,"Berry":{"HeapUsed":4,"Objects":45},"Wifi":{"AP":1,"SSId":"default3","BSSId":"14:EB:B6:B7:A4:FE","Channel":10,"Mode":"11n","RSSI":74,"Signal":-63,"LinkCount":1,"Downtime":"0T00:00:04"}}
22:49:34.314 HTP: Tools
22:49:35.268 HTP: Console
22:49:48.475 WIF: Checking connection...
22:49:53.982 BRY: GC from 4573 to 4212 bytes, objects freed 1/45 (in 0 ms) - slots from 51/122 to 50/122
22:49:53.992 MQT: tele/tasmota_75A3F8/STATE = {"Time":"2024-05-08T22:49:53","Uptime":"0T00:00:49","UptimeSec":49,"Heap":149,"SleepMode":"Dynamic","Sleep":50,"LoadAvg":19,"MqttCount":1,"Berry":{"HeapUsed":4,"Objects":45},"Wifi":{"AP":1,"SSId":"default3","BSSId":"14:EB:B6:B7:A4:FE","Channel":10,"Mode":"11n","RSSI":74,"Signal":-63,"LinkCount":1,"Downtime":"0T00:00:04"}}
22:50:08.494 WIF: Checking connection...
22:50:14.002 BRY: GC from 4581 to 4212 bytes, objects freed 1/45 (in 0 ms) - slots from 50/122 to 50/122
22:50:14.011 MQT: tele/tasmota_75A3F8/STATE = {"Time":"2024-05-08T22:50:13","Uptime":"0T00:01:09","UptimeSec":69,"Heap":149,"SleepMode":"Dynamic","Sleep":50,"LoadAvg":19,"MqttCount":1,"Berry":{"HeapUsed":4,"Objects":45},"Wifi":{"AP":1,"SSId":"default3","BSSId":"14:EB:B6:B7:A4:FE","Channel":10,"Mode":"11n","RSSI":74,"Signal":-63,"LinkCount":1,"Downtime":"0T00:00:04"}}
22:50:28.462 WIF: Checking connection...
22:50:33.970 BRY: GC from 4548 to 4212 bytes, objects freed 1/45 (in 0 ms) - slots from 50/122 to 50/122
22:50:33.979 MQT: tele/tasmota_75A3F8/STATE = {"Time":"2024-05-08T22:50:33","Uptime":"0T00:01:29","UptimeSec":89,"Heap":149,"SleepMode":"Dynamic","Sleep":50,"LoadAvg":19,"MqttCount":1,"Berry":{"HeapUsed":4,"Objects":45},"Wifi":{"AP":1,"SSId":"default3","BSSId":"14:EB:B6:B7:A4:FE","Channel":10,"Mode":"11n","RSSI":74,"Signal":-63,"LinkCount":1,"Downtime":"0T00:00:04"}}

Everything is working ok, ONLY with nodeMCU(ESP8266) and wemos d1 mini (ESP8266).

Any help would be appreciated becouse I'm really out of ideas.
Thank you in advance.

[valdus2]

Should I open an issue? I don't know what to do.

[arendst]

Leave it here for someone with a device and driver knowledge can start testing and debugging.

I guess the device has never been tested on ESP32....

[valdus2]

So, just waiting and hoping......Thank you arendst.