433Mhz Socket Actor Plugin for CraftBeerPi 3.0

This is an actor plugin for CraftbeerPi 3.0, which aims to provide a way to switch radio sockets on and off. Right now there is only one supported set, the silvercrest RCP DP3 3711-A.

Supported 433Mhz Socket

• Silvercrest RCR DP3 3711-A

Installation

You need to have a typical cheap 433Mhz sender installed on GPIO Pin 0 (default for 433Utils). You need wiringPi installed, but the craftbeerpi setup can do this for you.

Install 433Utils

git clone --recursive git://github.com/ninjablocks/433Utils.git
cd 433Utils/RPi_utils
make

Just download via CraftBeerPi Web Interface and restart CraftBeerPi.

Actor Configuration

SilverCrest433Mhz (hardcoded)

You can use an actor with hardcoded values. You need to train your sockets to know these values. Select "Silvercrest433Mhz" actor and select a socket. Simply put the receivers in a power socket and trigger "on" of your actor within 30 seconds.

Selflearning

You need known values to be sent as an on or off signal. You can use RFSniffer from 433Utils to find out.